i link 9500 hd private set up

kaniu · 08-10-2011, 04:09 PM

c/p:Heres the Ilink set up for NFPS...
Here we will show you how to use our private server step by step with your i-link!

1 - Menu – Options-network, enter net application , in this section change EPCs to Dream. In the menu where it says Server put the following address: fenfu.dynsite.net.

2 - In Port put the Port we sent you. In Authorization put your Access code.

3 – Then in Username and Password put your Access code again.

4 - And the Key is : 6103403445406970987123412134.

5 - Exit and wait until Picture comes or Try a Hard Reboot.

6 – WATCH TV!!

c/p EspoOrr
Here are the steps to take:
Menu, Sys Config, CC and NEWCAMD -on.
Next go to Network Setup, Server Settings, and turn Server 1 on, then enter all your info into the proper spots.
When done, MAKE SURE TO HIT THE BLUE APPLY BUTTON!!!!! or you have just wasted your time.
Also...i highly discourage using more then 1 PS with this box as it causes pixelation, freezing, and a heckuva hard time getting the box to respond again.

That back button was the whole key to get into it to put in the info

this is info i gathered up out of someone haveing hard time and the last bit of info to save was the trick.

08-10-2011, 04:09 PM	#1
kaniu Moderator X Join Date: Nov 2008 Posts: 137 Thanks: 5 Thanked 22 Times in 21 Posts Rep Power: 18	i link 9500 hd private set up c/p:Heres the Ilink set up for NFPS... Here we will show you how to use our private server step by step with your i-link! 1 - Menu – Options-network, enter net application , in this section change EPCs to Dream. In the menu where it says Server put the following address: fenfu.dynsite.net. 2 - In Port put the Port we sent you. In Authorization put your Access code. 3 – Then in Username and Password put your Access code again. 4 - And the Key is : 6103403445406970987123412134. 5 - Exit and wait until Picture comes or Try a Hard Reboot. 6 – WATCH TV!! c/p EspoOrr Here are the steps to take: Menu, Sys Config, CC and NEWCAMD -on. Next go to Network Setup, Server Settings, and turn Server 1 on, then enter all your info into the proper spots. When done, MAKE SURE TO HIT THE BLUE APPLY BUTTON!!!!! or you have just wasted your time. Also...i highly discourage using more then 1 PS with this box as it causes pixelation, freezing, and a heckuva hard time getting the box to respond again. That back button was the whole key to get into it to put in the info this is info i gathered up out of someone haveing hard time and the last bit of info to save was the trick.